I have been maintaining magazine length ammunition in evaluating several bullets and powder combinations with the Black Rain Ordnance PG4. However, I wanted to see if allowing the bullet to be closer to the lands would affect the group size. At the very bottom of the entry is a description of the sinclair tool and how I used it.
I chose to use 77 grain Sierra Match King bullets with Vihtavouri N540 powder from magazine length (2.260) to within 10 thousands of the rifling (and thus require loading them one at a time). A magneto speed chronograph was used to obtain preliminary velocity data over the expected loading range. 24.5 grains was selected as a starting point for load development for this experiment with an expected velocity of approximately 2800 fps. This powder and charge had been previously tested and found to be sub moa at 100 yards at magazine length (in addition to being safe with no pressure signs). This rifle is hoped to be competitive at 300 to 600 yards, and so heavy for caliber bullets with high ballistic coefficients that could still be fired with good velocity out of the 1 in 8 twist barrel was preferred.
Rifle: Black Rain Ordnance PG4, 5.56/223, AR15 style rifle with a 24 inch bull barrel.
Brass: Lake City (new from the same lot)
Brass prep: Mouth of brass was chamfered with Lyman VLD chamfer, deburred with Wilson debur tool. Brass was sprayed with Hornady One Shot (including into the neck), and then full length resized using stander Redding dies and a carbide ball expander.
Primer: CCI 41 primed using a RCBS priming tool
Powder: N540 at 24.5 grains using a Harrel's Premium Powder measure and Hornady scale
Bullet: Sierra Match King 77 grain seated to depth with standard redding dies
Previously, a test of powder (Viht N540) vs velocity was conducted over the recommended range of powder weight using a magneto chronograph.
The seating depth experiment was setup using a sinclair measurement tool for an AR15.
The final experiment consisted of bullets at 0.010, 0.050, 0.090, and 0.11 jump corresponding to OAL (overall length) of 2.3585, 2.3185, 2.2800, and 2.2600 as measured. 2.260 was used since that is usually the length associated with the maximum magazine length.
Each length has 15 bullets prepared, for three 5 shot groups. Shooting was done on a rest, rear bag, using a Sinclair benchrest adapter for a picatinny rail. The results show that longer than magazine length did improve the group size from an average of 0.920 to 0.776 inches at 100 yards. The rifle at 300 yards using 2.260 inch OAL bullets had grouped 2.1 inches at 300 yards during a visit to a Washington State range (off bipod, prone), and the 10 shot group is shown below.
Other bullets and the measurements with the Sinclair measurement tool included the following for later load development.
Black Rain Rifle
Five shot groups at 100 yards
10 shot group at 300 yards, prone, using a bipod (in Washington State)
Steps to using the Sinclair Tool in the AR15 (measurements are not of the black rain rifle)
